Class 2 Build w/ ScalerFab Pro Series Front Bumper

Apr 5, 2016
2 min read

Been working on my class 2. It went through a complete make over installed a GCM front mount, ScalerFab sliders,front bumper, rear bumpers and a servo winch. Ran into a few small hang ups but got them worked out.

The gcm mount is of good quality but I didn't like how the servo winch with a bobbin fit. After a lot of head scratching I relocated the winch to the rear crossmember. I still have to run antenna tubing and line and hope it works right. If it don't I'll go back to the standard winch on my new ScalerFab front bumper.

Installing the front bumper was easy. The fit and quality are top notch. Since I wasn't using the second servo mount that allowed me to put two extra bolts in from the top down. The rear bumper was straight forward with no issues just removed the old one and installed the new one.

Slider install was simple and all the holes lined up perfectly. I was a little unsure about where about which location to put my upper links in but after some helpful hints from my fellow team members they went in the top most forward location. After my short test drive I can say that was a huge improvement in my rigs handling. I did have to modify the skids to fit my growlers on custom wheels and the little extra width of my xr mod but it wasn't anything crazy.

Here are some photos for your pleasure. I know I enjoyed driving it to get them. Excited to finally be back in the c2 comp scene.